Skidoo Bolt-On Rack Install

If you haven't already installed your ski/board brackets you can find those instructions here.

 

GUIDE:

You will need:

• Skidoo Bolt-On Rack with Skidoo Hardware

• A T30 Driver
• 7/16” Wrench or Socket/Driver

 

Put the rack in place. The bolts install from underneath the tunnel through the backer plates with the shoulders on the backer plates facing up into the LinQ holes in the tunnel as shown.

 

Bolt the rack to the tunnel with the 1/4-20 nyloc nuts and washers to the bolts.

 

Make sure the shoulders of the backer plate are within the LinQ holes and the backer plate sits flush against the bottom of the tunnel as you tighten.